Rapid Stripping of Brass-plating on Fine Saw Wire by Triangle-type Multiple Magnetron Plasmas

Authors

  • H. Fujiyama Graduate School of Engineering, Nagasaki University, Japan
  • K. Miyazaki Graduate School of Engineering, Nagasaki University, Japan
  • N. Matsuo Graduate School of Engineering, Nagasaki University, Japan
  • Y. Kobayashi Graduate School of Engineering, Nagasaki University, Japan
  • M. Shinohara Graduate School of Engineering, Nagasaki University, Japan
  • S. Nishiyama Japan Fine Steel CO. Ltd., Japan

DOI:

https://doi.org/10.3384/wcc2.195-198

Abstract

To remove brass plating on fine saw wire, line-shaped magnetron plasma source has been newly developed. New type of multiple plasma sources has been developed by applying to multiple-triangle-type electrodes. The stripping effects were successfully established by using high density magnetron source with 20mm gap in an axially applied magnetic field. From the EDS analysis results of wire surface after plasma stripping during 30sec, it is clearly shown that Zn was removed after 10sec stripping and Cu after 30sec. (Fe:38.5%?97.7%, Cu:39.3%?2.43%, Zn:22.2%? 0.03%)

Downloads

Published

2013-03-04

How to Cite

1.
Fujiyama H, Miyazaki K, Matsuo N, Kobayashi Y, Shinohara M, Nishiyama S. Rapid Stripping of Brass-plating on Fine Saw Wire by Triangle-type Multiple Magnetron Plasmas. PSE [Internet]. 2013 Mar. 4 [cited 2024 Nov. 21];2(13):195-8. Available from: https://wcc.ep.liu.se/index.php/PSE/article/view/428

Issue

Vol. 2 No. 13 (2012): 13th International Conference on Plasma Surface Engineering September 10 - 14, 2012, in Garmisch-Partenkirchen, Germany

Section

Poster: Plasma and ion etching / surface cleaning