The Corrosion Properties of Zirconium and Titatium Loadbearing Implant Materials with Protective Oxide Coatings

Authors

  • Anna Zykova Institute of Surface Engineering, Kharkov, Ukraine and National Science Centre, Kharkov Institute of Physics and Technology, Kharkov, Ukraine
  • Vladimir Safonov National Science Centre, Kharkov Institute of Physics and Technology, Kharkov, Ukraine
  • Jerzy Smolik Institute for Sustainable Technologies, National Research Institute, Radom, Poland
  • Renata Rogowska Institute for Sustainable Technologies, National Research Institute, Radom, Poland
  • Vladimir Lukyanchenko Inmasters Ltd, Kharkov, Ukraine
  • Oleg Vyrva Sytenko Institute of Spine and Joint Pathology, Kharkov, Ukraine
  • Stas Yakovin Department of Physical Technologies, Kharkov National University, Kharkov, Ukraine

DOI:

https://doi.org/10.3384/wcc2.388-391

Abstract

At present study the comparative analysis of parameters for oxide Al2O3 and ZrO2 films deposited by reactive magnetron sputtering (RMS) method on the load-bearing implant materials such as titanium-based (Ti4Al6V) and Zr has been made. The corrosion examinations of anodic polarization by potentiodynamic method, Tafel and Stern curves and also impedance method at SBF solution were presented.

Downloads

Published

2013-03-04

How to Cite

1.
Zykova A, Safonov V, Smolik J, Rogowska R, Lukyanchenko V, Vyrva O, Yakovin S. The Corrosion Properties of Zirconium and Titatium Loadbearing Implant Materials with Protective Oxide Coatings. PSE [Internet]. 2013 Mar. 4 [cited 2024 Dec. 22];2(13):388-91. Available from: https://wcc.ep.liu.se/index.php/PSE/article/view/475

Issue

Vol. 2 No. 13 (2012): 13th International Conference on Plasma Surface Engineering September 10 - 14, 2012, in Garmisch-Partenkirchen, Germany

Section

Poster: Bioactive films and surfaces